EPEVER SOLAR Cost CONTROLLER SETUP: TRACER AN Sequence CONTROLLE

EPEVER SOLAR Cost CONTROLLER SETUP: TRACER AN Sequence CONTROLLE

Blog Article

The EPEVER Tracer AN Collection Solar Charge Controller is a very successful photo voltaic controller designed for off-grid solar programs. Based on multiphase synchronous rectification technological innovation, it makes certain optimized Electrical power conversion and system stability for a wide range of photovoltaic (PV) programs.

Crucial Characteristics on the EPEVER Tracer AN Collection Controller
The Tracer AN sequence makes use of EPEVER Solar Demand Controller technology for exceptional solar Power harvesting. Important functions contain:

Multiphase Synchronous Rectification (MSR) for improved Vitality conversion.
Sophisticated MPPT Algorithm with >ninety nine% performance.
Twin-Phase Charging for Increased battery lifetime.
LCD Screen with true-time info checking.
Multiple Load Manage Modes such as manual and timer.
Complete Electronic Protections in opposition to overcharging, about-discharging, small circuits, and reverse polarity.
Action-by-Move Guide to Starting the EPEVER Tracer AN Collection Controller
1. Unboxing and Making ready the Controller
Be certain all factors are integrated: Tracer AN unit, temperature sensor, conversation cables, and consumer manual.
Verify the product range and voltage rankings match your photo voltaic panel and battery technical specs.
two. Mounting the Cost Controller
Pick a effectively-ventilated, dry area close to the battery lender.
Protected the Tracer AN controller using the offered mounting brackets.
Manage good clearance for warmth dissipation.
3. Wiring the Solar Charge Controller
Caution: Constantly adhere to correct safety protocols and make sure the technique is driven off before connecting factors.

Phase 1: Connect the battery terminals into the cost controller (optimistic to good, damaging to unfavorable).
Move two: Link the photo voltaic panel array to your PV enter terminals.
Action three: Connect the load terminals if employing a direct load connection.
Action visit here 4: Double-Verify all connections for polarity and tightness.
four. Configuring the Controller Options
Electrical power on the controller by connecting the battery to start with.
Make use of the Liquid crystal display display to navigate the configurations menu.
Configure:
Battery Sort: AGM, GEL, Flooded, Lithium.
Charging Parameters: Absorption voltage, float voltage.
Load Control Modes: Guide, timer, light Command.
5. Checking and Knowledge Logging
The Tracer AN Series supports serious-time monitoring utilizing the MT50 distant meter.
Knowledge may be logged by using the RS485 conversation port applying program for example Solar Station Laptop.
Remote checking is achievable Using the EPEVER WiFi module.
six. Troubleshooting Frequent Difficulties
Challenge 1: No Ability Output

Test battery voltage and connections.
Confirm PV panel voltage exceeds battery voltage.
Difficulty 2: Around-Voltage Safety

Validate the solar array’s voltage rating.
Regulate procedure parameters if necessary.
Problem 3: No Battery Charging

Inspect PV wiring for continuity.
Validate MPPT configurations during the menu.
Great things about the Tracer AN Series with MSR Engineering
The multiphase synchronous rectification know-how makes sure:

Bigger Efficiency: Reduced Power losses through conversion.
Increased Trustworthiness: Secure general performance under variable loads.
Lengthier Battery Everyday living: Consistent and accurate charging profiles.
Conclusion
The EPEVER Solar Charge Controller with multiphase synchronous rectification technological innovation is undoubtedly an Outstanding choice for optimizing solar power era and lengthening battery lifetime. By pursuing the above mentioned set up guide, customers can make certain highest efficiency and system longevity.